ZETRON 2000 Series Especificaciones descargar pdf (Pagina 42)

System Installation

42 025-9035AA

3. Verify that all trunk, multiport, and station cards on both the main and 2200EX

chassis have both SELECT and T1 through Tn LEDs flashing quickly.

At this point, you should be able to proceed with interfacing the new cards in the

expansion chassis to their respective equipment. If you experience any difficulty, please

contact Zetron Technical Support (at 425-820-6363) for assistance.

2000 Series Printer Option

ZCPU Serial Printer Port

The 2000 Series Printer Option (Part No. 950-9118) lets you connect a serial printer to a

2000 Series terminal for real-time printing of paging traffic. This option is only used with

a Zetron CPU card.

Your printer must have a serial interface. This option package does not use the more

common parallel printer interface. Your serial interface needs to be set up as follows:

4800 baud rate (software-settable, see PrinterPost on page 272)

8 bits

No parity

1 stop bit (2 stop bits usually work OK)

The cable (Part No. 709-7085) that we supply is wired as shown in the wiring diagram

below. It works for most printers, for instance an Epson printer with an Epson 8145 serial

interface option card.

The cable is plugged into the connector mounted on the lower backplane (on a bracket on

current machines). It should be labeled “PRINTER”.

2200EX Chassis WR LED = Blinking

RD LED = Flashes as the cards load

Note There is no need for the printer or the printer cable to be hooked

up to the paging terminal. The status of the printer does not matter

to the terminal. The printer can run out of paper, jam, go off-line,

or be turned off - none of this will affect the paging terminal. So,

be sure to check it as needed for enough paper and that it has not

jammed.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 375 376

Sin comentarios

ZETRON 2000 Series Especificaciones Pagina 42