ZETRON 2000 Series Especificaciones descargar pdf (Pagina 274)

System Configuration Files

274 025-9035AA

The ZlinkW command “note” will display the current reminder settings, as well as any

reminder or test pages currently active.

You may disable reminder pages, and thus notify mode, by setting Reminders to zero, or

by following either the Reminders or ReminderTime command with the parameter OFF.

In a similar fashion, you may set the number of reminders and interval between reminder

pages to their defaults by following either command with the ON parameter. When

selecting these modes only the Reminders or ReminderTime command should be used, not

both commands.

Reminders

The Reminders command sets the number of notification pages sent for each incoming

Notify mode call. The number of reminder notifications may be set from zero, in which

case the function is disabled, to a maximum of 255.

REMINDERS 3 ; send 3 reminders per Notify mode page

ReminderTime

The ReminderTime command sets the interval between the sending reminder pages. The

range of allowable values is zero to 255 minutes, in 1-minute increments. A value of zero

will result in all the reminder pages, as determined by the Reminders command, being sent

very quickly.

REMINDERTIME 10 ; ten minutes between each reminder page

REMINDERS OFF ; disable the sending of Notify reminders

REMINDERS ON ; use default values for the generation

; Notify reminders

RetrievalStart

The RetrievalStart command is just like the MailStart command, but applies only to

Retrieval records (records with a status of R). The default is NEWEST. This is because

callers to status R records have no control over mailbox actions and cannot delete older

messages, so we might as well play the newer ones first.

SilenceDuration / SilenceLevel

The Pause deletion feature is controlled by the SilenceDuration and SilenceLevel

commands, if the ADPCM (702-9153) card is installed. The PCM voice controller uses

hardware switches to select its options, see Voice Storage System on page 197, for more.

The SilenceDuration command needs a single integer value as a parameter. This value is

the length of time, in 1/16s of a second, of silence that will trigger pause deletion. Periods

of silence less than this time will not be affected. This value should not be set less than 5

(0.32 seconds), as it may cause unpleasant or odd sounding recorded speech. The

maximum value is 255, or 16 seconds, which is far too long to be useful. Typically, a value

of 5 to 9 works well.

The SilenceLevel command needs a single integer value as a parameter. This value

generally should be between 200 and 330, with 300 being near optimal.

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 375 376

Sin comentarios

ZETRON 2000 Series Especificaciones Pagina 274