ZETRON 2000 Series Especificaciones descargar pdf (Pagina 105)

105

Station Card Removal/Installation

Should it be necessary to remove/install a station card in the paging terminal, use the

following procedure.

♦ Removing/installing a station card

1. Remove the front cover.

2. Turn off the AC power.

3. Pull on the two black, nylon, retainer latches and gently wiggle the card out of its

sockets. Slide the card out of the card-cage and place it on anti-static foam.

4. Slide the new card into the card cage.

5. Make sure that the nylon latches are extended toward you. Otherwise, the card

edge connectors will not plug in. Push on the card faceplate to fully seat the card

into the card cage. Then push on the nylon latches to lock the card into place.

6. Turn on the AC power. After about 30 seconds, you should see the SELECT lights

on each card begin to blink as the CPU loads software into each card. The

configuration files in the terminal need to be updated by Zetron in order for the

terminal to recognize a new card(s).

Switch Settings

The switches on the station card 702-9038 should be set to match the card cage slot

number that the card is installed in. Station cards may be installed into Model 2200: slots

15 and 16 in backplane 702-9071 Rev A, B or slots 13 through 16 for 702-9071 Rev B and

C. On the Model 2100, you have two slots to work with; 9 and 10. The following table

shows the switch settings.

Note Be sure to set the Address Switches on the replacement card to the

same as those on the card removed from the card cage. If slot was

empty, see chart of switch settings below.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 375 376

Sin comentarios

ZETRON 2000 Series Especificaciones Pagina 105