ZETRON 2000 Series Especificaciones descargar pdf (Pagina 25)

Overview

System Installation

Overview

This section contains the information necessary to install and adjust the paging terminal.

The information is contained in the form of checklists and step-by-step procedures. Where

appropriate, procedures in this section refer to information contained in specific sections

elsewhere in this manual.

Installation of the 2000 Series Paging Terminal is usually accomplished in three major

steps:

• Connect a telco line (or local telephone) and the radio system in a temporary setup

for checkout and make it ready for rapid cut over into an existing system. (If this is

a new installation, you can install the system in its permanent location and connect

the new telco lines for checkout.)

• Install the system software onto the office computer, enter pagers into the database,

and perform some test paging operations.

• Mount and connect the working system into its permanent installation.

The installation procedures contained in this section consist of the three basic operations

listed above to connect the system temporarily, perform some test pages, and then install

the paging terminal in its permanent location. An installation procedure/checklist is

provided that lists the specific steps to take during installation of the paging terminal, and

where necessary, refers to more detailed information contained in other sections of this

manual.

To install the paging terminal in your facility, complete each of the steps (in order) of the

Installation Checklist contained on the following pages.

Warning! ALWAYS TURN OFF POWER BEFORE INSERTING OR

REMOVING CARDS!

Removing or inserting cards with power on can cause serious

damage to your terminal. The 2000 Series Paging Terminals

use a bus backplane much like a personal computer, and are

not designed for “hot” removal of cards.

STOP

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 375 376

Sin comentarios

ZETRON 2000 Series Especificaciones Pagina 25