
PART THREE - ADVANCED FEATURES
001-0131B October 1997 Page 15
3.2.5 Do you want to provide interconnect forwarding from the paging terminal to a Johnson RIC,
GEMARC Phone Patch, or other phone patch with an end-to-end line (POTS) interface?
yes
no
If desired, order the -B47 routing option.
3.2.6 Do you need to route calls to any devices which require a ringing voltage in order to
respond?
yes
no
Some equipment needs to receive ringing voltage in order to respond to an incoming call. This occurs
when the paging terminal is acting as the TELCO side of the interface on an end-to-end phone line. This
includes the phone patches (section 3.2.5), forwarding to a PABX into an end-to-end line (section 3.2.1),
and a stand-alone phone manned by an operator (section 2.5.3.3.1). If ring generators are needed, then
order the quantity of ring generators (901-9212) and power adapters (815-9012) needed for each trunk
card that will be used to route calls to devices needing ring generators.
3.2.7 Do you want to provide the ability for the paged party to rendezvous with their caller?
yes
no
Rendezvous paging makes it possible for a caller to hold while a subscriber is paged. When the page is
received, the subscriber calls the paging terminal and is connected with the caller. If desired, order the -
B24 routing option.
3.2.8 Do you want to allow a single DID number the ability to route calls between multiple
destinations (e.g., mailboxes, pagers, or mobile phone)?
yes
no
If desired, order the -B25 caller directed routing option.
3.2.9 Pathfinder Software Ordering
If any of the preceding -BXX options in sections 3.2.1 to 3.2.8, or 2.5.3.3.1 have been ordered, then order
the basic PathFinder software (950-9181).
3.2.10 Will you be doing talkback paging on any channel?
yes
no
Talkback paging allows callers to signal to mobile or portable radios and engage them in two-way
communications. Talkback paging requires the use of a full-duplex repeater. This option supports only
two-tone encoding for selective signaling of the mobiles/portables. The radios cannot initiate calls through
the 2000 Series paging terminal. If desired, order the -B08 talkback paging option.
Comentarios a estos manuales